Before first use, low-cost trackers must be awakened from sleep mode to start measurements and send transmissions. Follow these steps:
-
Remove the cover from the lens
-
Shake the device several times in the ToF direction.
-
Check the LED on the back of the device.
-
-
If Step 2 was successfully completed, the LED on the back should light up (mode “Always On”).
-
If the LED does not light up, repeat Step 2.
-
4. Verify whether the registration was successful:
-
Observe the LED:
-
- The LED will blink rapidly for 3 seconds and then turn off, indicating that the device has been successfully activated.
- This process can take up to 3 minutes. After successful activation, the LED will not light up even if Step 2 is repeated.
-
Observe the LED:
-
- If the LED turns off without blinking, the activation procedure has failed.
- Possible causes:
- An invalid network.
- An issue with Deutsche Telekom’s gIoT Cloud platform.
